LJIEE TAKER F722 BLS 100A 8S STACK

Feature

• Uses the mainstream STM32F722 chip
• Equipped with the latest 42688-P gyroscope
• 16M onboard black box storage
• Integrated LC filter
• Upgraded Type-C USB interface
• Directly plugs into the DJI Air Unit
• Paired with the TAKER H100_8S_BLS 100A 4IN1 ESC, providing a smooth flying experience
• Simple and efficient installation method with shock absorbers for stable gyroscope performance
• Dual independent BECs: 12V@3A and 5V@3A
• Supports 8S Lipo batteries
• Supports direct insertion of 8 motors

Specifications

TAKER F722 8S Flight Controller

• MCU: STM32F722
• IMU: ICM42688-P (SPI)
• Air Unit Connection: Direct plugs into DJI Air Unit
• Black Box: 16M onboard
• USB Interface: Type-C
• Barometer: Supported
• OSD: BetaFlight OSD w/ AT7456E chip
• BEC: 5V@3A, 12V@3A dual BEC
• Firmware Target: TAKERF722SE
• Dimension: 38.5×38.5mm
• Mounting Hole Size: 30.5×30.5mm，φ4mm hole becomes φ3mm after using a silicone shock-absorbing circle
• Input Voltage: 3-8S LiPo
• UART: 6 UARTs
• Power Filter: Integrated LC filter
• Weight: 8.1g

TAKER H100_8S_BLS 100A 4IN1 ESC

• Input Voltage: 3-8S Lipo
• Ammeter: Support
• Calibration value: 200
• Continue Current: 100A
• Burst Current: 105A (5 seconds)
• Support Protocol: Dshot 150/300/600
• Size: 56.3×61.1 mm; hole: 30.5×30.5 mm; φ4 mm hole becomes φ3mm after using the silicone shock-absorbing ring
• Weight: 28.8g
• Target: B_X_30

Includes

• 1 x FC board
• 1 x ESC board
• 1 x Capacitor
• 1 x O3 3-in-1 connection cable
• 2 x FC adapter cable
• 1 x sh1.0 4pin silicone cable
• 1 x Camera connection cable
• 1 x VTX connection cable
• 1 x XT90 power cable
• 4 x M3×30 screws
• 4 x M3×25 screws
• 8 x Nylon nuts
• 12 x Silicone anti-shake pads